CADDX NX540 Manuel d'installation télécharger pdf (Page 2)

NX-4 Control

Page 2

IMPORTANT NOTES

GENERAL DESCRIPTION

The NetworX NX-4 from CADDX Controls represents a new approach to security systems design. Drawing on our

experience in the world market as the largest exporter of USA manufactured controls, CADDX has developed the most

flexible, durable, and user-friendly control ever seen in our industry. Featuring sophisticated software which allows

up to 8 users to interface with 8 zones, and a host of integrated fire, access, verification, and input/output modules,

all reported with the most comprehensive and fast SIA and Contact ID formats. The NetworX design allows a fully

loaded system to be housed in one single metal enclosure, establishing for the first time, a logical solution and design

response to modular systems. A maximum of 8 keypads and 1 other module (excluding hardwire) can be added to

expand the capabilities of the NX-4 unit.

ORDERING INFORMATION

CADDX PART # DESCRIPTION

NX-4 KIT Includes NX-4 Control, NX-108 LED Keypad, & 16.5V 25VA Transformer

NX-4 NX-4 Control Only

NX-108 8 Zone LED Keypad

NX-116 16 Zone LED Keypad

NX-124 24 Zone LED Keypad

NX-148 Alphanumeric LCD Keypad

NX-200 ** Zone Doubling Kit (Includes 100 3.74k and 100 6.98k resistors)

NX-320 ** Smart Power Supply and Buss Extender

NX-408 # 8 Zone Wireless Expansion Module (UL LISTED PART #60-732)

NX-416 # 16 Zone Wireless Expansion Module (UL LISTED PART #60-732)

NX-448 # 48 Zone Wireless Expansion Module (UL LISTED PART #60-732)

NX-508 Eight Output Module

NX-534 ** Two-Way Listen In Module

NX-535 ** Two-Way Voice Module

NX-540 ** "Operator II" Telephone Interface Module

NX-580 ** Cellemetry Interface

NX-1308 ** 8 Zone LED Door Design Keypad

NX-1316 ** 16 Zone LED Door Design Keypad

NX-1324 ** 24 Zone LED Door Design Keypad

** These products have not been tested and approved by Underwriters Laboratories, Inc.

# These wireless devices are only UL listed for residential applications.

1. The maximum number of zones available is 8 regardless of devices added. Information regarding Zone Doubling

is located on page 7.

2. The NX-4 control panel will send an “Expander Trouble” once each hour if it senses that no devices have been

enrolled. This report will show “Expander Trouble” - device zero (0).

NX-4 BOARD INSTALLATION

The metal enclosure should be installed with the door opening from top to bottom. Refer to the diagram on

the right.

Inside the can, there are four slots for board insertion, two on the top and two on the bottom of the can.

These allow the PC board to be positioned vertically as shown in the diagram. When you slide the board

between the grooves of the slots, make sure the terminal strip is toward the front for wire connections.

1 2 3 4 5 6 7 ... 41 42

Commentaires sur ces manuels

Pas de commentaire

CADDX NX540 Manuel d'installation Page 2

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité CADDX NX540