CADDX NX540 Manuel d'installation télécharger pdf (Page 39)

NX-4 Control

Page 39

LOCAL TELEPHONE COMPANY INTERFACE INFORMATION

TELEPHONE CONNECTION REQUIREMENTS

Except for telephone company provided ringers, all connections to the telephone network shall be made

through standard plugs and standard telephone company provided jacks or equivalent in such a manner as to

allow for immediate disconnection of the terminal equipment. Standard jacks shall be so arranged that if the

plug connected thereto is withdrawn, no interference to the operation of the equipment at the customers

premises which remains connected to the telephone network, shall occur by reason of such withdrawal.

INCIDENCE OF HARM

Should terminal equipment or protective circuitry cause harm to the telephone network, the telephone

company shall, where practical, notify the customer that temporary discontinuance of service may be

required. However, where prior notice is not practical, the telephone company may temporarily discontinue

service if such action is deemed reasonable in the circumstances. In the case of such temporary

discontinuance, the telephone company shall promptly notify the customer who will be given the opportunity

to correct the situation. The customer also has the right to bring a complaint to the FCC if he feels the

disconnection is not warranted.

CHANGES IN TELEPHONE COMPANY EQUIPMENT OR FACILITIES

The telephone company may make changes in its communications facilities, equipment, operations, or

procedures where such action is reasonably required and proper in its business. Should any such change

render the customers terminal equipment incompatible with the telephone company facilities, the customer

shall be given adequate notice to make modifications to maintain uninterrupted service.

GENERAL

The FCC prohibits customer provided terminal equipment be connected to party lines.

IMPORTANCE OF THE RINGER EQUIVALENCE NUMBER

The Ringer Equivalence Number (REN) of this device is 0.1B. This number is a representation of the electrical

load that it applies to your telephone line.

MALFUNCTION OF THE EQUIPMENT

In the event that the device should fail to operate properly, the customer shall disconnect the equipment from

the telephone line to determine if it is the customers equipment that is not functioning properly. If the

problem is with the device, the customer shall discontinue use until it is repaired.

EQUIPMENT INFORMATION

MANUFACTURER OF CONNECTING EQUIPMENT: CADDX CONTROLS, INC.

FCC REGISTRATION NUMBER: GCQUSA-33408-AL-E, RINGER EQUIVALENCE: 0.1 B

1 2 ... 34 35 36 37 38 39 40 41 42

Pas de commentaire

CADDX NX540 Manuel d'installation Page 39