CADDX NX-6 Manuel d'installation télécharger pdf (Page 54)

GE Security

Programming the outputs

LOCATION 45 - AUXILIARY OUTPUT 1-4 PARTITION SELECTION (4 segments, feature selection data)

Location 45 is used to select the partition(s) in which the events must occur before the

output(s) will activate. Location 45 has 4 segments. Segment 1 corresponds to output 1,

and segment 2 corresponds to output 2, segments 3 and 4 correspond to outputs 3 and

Segment 1

(Auxiliary 1)

Segment 2

(Auxiliary 2)

Segment 3

(Auxiliary)

Segment 4

(Auxiliary)

1= Partition #1 1= Partition #1 1= Partition #1 1= Partition #1

2= Partition #2 2= Partition #2 2= Partition #2 2= Partition #2

3-8 Reserved 3-8 Reserved 3-8 Reserved 3-8 Reserved

LOCATION 46 - AUXILIARY OUTPUT 1-4 SPECIAL TIMING (4 segments, feature selection data)

Location 46 contains special timing feature activation for the 4 auxiliary outputs (relays).

Segment 1 corresponds to output 1, segment 2 corresponds to output 2. Segments 3 and

4 correspond to outputs 3-4.

Segment 1-4

1 =

On: if output should be timed in minutes; Off: if timed in

seconds

2 = On: if output should latch; Off: if output should be timed

3 =

On: if output should stop timing when the code is entered; Off:

if the output should continue to time when the code is entered

4 =

On: if output should only activate between the closing and

opening time in locations 52 and 53

5 =

On: if output should only activate between the opening and

closing time in locations 52 and 53

6 =

On: if output should be inverted (0 volts going to 12 volts when

activated)

7 = Reserved

8 = Reserved

NX-6-EUR Installation manual Page 54 23/12/04

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 103 104

Pas de commentaire

CADDX NX-6 Manuel d'installation Page 54