CADDX NX-6 Manuel d'installation télécharger pdf (Page 73)

GE Security

LOCATION 138 - CONFIGURATION GROUP 15 ALARM EVENT CODE (1 segment, numerical data)

Location 138 contains the event code that is sent for a Contact ID or SIA report. The

desired event code should be chosen from the list on pages 121-122. The zone ID will be

the zone that is in alarm.

This location is not used for slow speed formats (like 4+2 and 3+1). This location may

also contain the alarm report code for the Robofon format (value 00-99).

LOCATION 139 - CONFIGURATION GROUP 15 CHARACTERISTIC SELECT (5 segments, feature

selection data)

Use the “Configuration Group Characteristic Selections” described in Location 111.

LOCATION 140 - CONFIGURATION GROUP 16 ALARM EVENT CODE (1 segment, numerical data)

Location 140 contains the event code that is sent for a Contact ID or SIA report. The

desired event code should be chosen from the list on pages 121-122. The zone ID will be

the zone that is in alarm.

This location is not used for slow speed formats (like 4+2 and 3+1). This location may

also contain the alarm report code for the Robofon format (value 00-99).

LOCATION 141 - CONFIGURATION GROUP 16 CHARACTERISTIC SELECT (5 segments, feature

selection data)

Use the “Configuration Group Characteristic Selections” described in Location 111.

LOCATION 142 - CONFIGURATION GROUP 17 ALARM EVENT CODE (1 segment, numerical data)

Location 142 contains the event code that is sent for a Contact ID or SIA report. The

desired event code should be chosen from the list on pages 121-122. The zone ID will be

the zone that is in alarm.

This location is not used for slow speed formats (like 4+2 and 3+1). This location may

also contain the alarm report code for the Robofon format (value 00-99).

LOCATION 143 - CONFIGURATION GROUP 17 CHARACTERISTIC SELECT (5 segments, feature

selection data)

Use the “Configuration Group Characteristic Selections” described in Location 111.

LOCATION 144 - CONFIGURATION GROUP 18 ALARM EVENT CODE (1 segment, numerical data)

Location 144 contains the event code that is sent for a Contact ID or SIA report. The

desired event code should be chosen from the list on pages 121-122. The zone ID will be

the zone that is in alarm.

This location is not used for slow speed formats (like 4+2 and 3+1). This location may

also contain the alarm report code for the Robofon format (value 00-99).

NX-6-EUR Installation manual Page 73 23/12/04

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 103 104

Pas de commentaire

CADDX NX-6 Manuel d'installation Page 73