CADDX NX-6 Manuel d'installation télécharger pdf (Page 75)

GE Security

LOCATION 152 - CONFIGURATION GROUP 22 ALARM EVENT CODE (1 segment, numerical data)

Location 152 contains the event code that is sent for a Contact ID or SIA report. The

desired event code should be chosen from the list on pages 121-122. The zone ID will be

the zone that is in alarm.

This location is not used for slow speed formats (like 4+2 and 3+1). This location may

also contain the alarm report code for the Robofon format (value 00-99).

LOCATION 153 - CONFIGURATION GROUP 22 CHARACTERISTIC SELECT (5 segments, feature

selection data)

Use the “Configuration Group Characteristic Selections” described in Location 111.

LOCATION 154 - CONFIGURATION GROUP 23 ALARM EVENT CODE (1 segment, numerical data)

Location 154 contains the event code that is sent for a Contact ID or SIA report. The

desired event code should be chosen from the list on pages 121-122. The zone ID will be

the zone that is in alarm.

This location is not used for slow speed formats (like 4+2 and 3+1). This location may

also contain the alarm report code for the Robofon format (value 00-99).

LOCATION 155 - CONFIGURATION GROUP 23 CHARACTERISTIC SELECT (5 segments, feature

selection data)

Use the “Configuration Group Characteristic Selections” described in Location 111.

LOCATION 156 - CONFIGURATION GROUP 24 ALARM EVENT CODE (1 segment, numerical data)

Location 156 contains the event code that is sent for a Contact ID or SIA report. The

desired event code should be chosen from the list on pages 121-122. The zone ID will be

the zone that is in alarm.

This location is not used for slow speed formats (like 4+2 and 3+1). This location may

also contain the alarm report code for the Robofon format (value 00-99).

LOCATION 157 - CONFIGURATION GROUP 24 CHARACTERISTIC SELECT (5 segments, feature

selection data)

Use the “Configuration Group Characteristic Selections” described in Location 111.

LOCATION 158 - CONFIGURATION GROUP 25 ALARM EVENT CODE (1 segment, numerical data)

Location 158 contains the event code that is sent for a Contact ID or SIA report. The

desired event code should be chosen from the list on pages 121-122. The zone ID will be

the zone that is in alarm.

This location is not used for slow speed formats (like 4+2 and 3+1). This location may

also contain the alarm report code for the Robofon format (value 00-99).

NX-6-EUR Installation manual Page 75 23/12/04

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 103 104

Pas de commentaire

CADDX NX-6 Manuel d'installation Page 75